BK-HidroStop 2

Flexibile two-component waterproofing coating

BK-HidroStop 2

Consumption Calculator

You need kg of this product


Two component, waterproofing, polymer-cement coating for horizontal and vertical protection of surfaces from moisture. It is used for waterproofing of potentially damp rooms: kitchens, bathrooms, showers, swimming pools, basements, terraces, etc. It is intended for indoor and outdoor use, for positive and negative water pressure ≤1,5 bar. Suitable for insulation of surfaces that are in prolonged direct contact with water.


The substrate to which BK-HidroStop 2 is applied must be solid, dust-free, free of grease, mold and loosely bonded parts. Before applying waterproofing, it is advisable to apply the BK-Ultra Prime primer diluted according to the instructions. In case of old and unevenly absorbent substrates, as well as in the case of porous high absorbent substrates, it is necessary to coat the substrate with diluted BK-Ultra Prime, min. 4h before waterproofing. In case of peeled off, worn and/or dusty surfaces, all loosely bonded layers must be removed and then impregnated with BK-Penetrat. It is necessary to thoroughly wash the concrete surfaces with hot water in order to remove the impurities present and then coat with BK-BetonKontakt.
The preparation of the compound is performed by lightly mixing the powder component A with the liquid component B without the addition of the water. Allow the compound to rest for about 5 minutes and stir again. Homogenize the compound well. The application is carried out with a brush in two coatings, in cross motions. If necessary, a third coat can also be applied. The thickness of a single layer is approximately 1-2 mm, and the subsequent layer should be applied after the previous one has cured. Use prepared compound within 1 hour. The waterproofing coating should be protected from rapid drying. After 12 hours from the application of the last layer, the surface is ready for laying ceramics (for gluing use flexible adhesives SiproFix BK-110 Flex, BK-160 Super Flex, BK-155 Rapid White, BK-170 Elastic or BK-160 White). See product datasheet for more detailed instructions.


Approximately 1.50- kg/m²/mm, depending on the quality of the substrate.


12 months in original packaging in dry room on pallets.


Component A – 16,6 kg

Component B – 5 kg